Whirlpool Cabrio,- WED7300X Instal Manual - Halaman 6

Remove drain hose form

(floor drain installations only)

For floor drain installations, you will need to remove the drain

hose form from the end of the drain hose. You may need

additional parts with separate directions. See "Tools and Parts".

CONNeCT INLeT hOses

Washer must be connected to water faucets with new inlet

hoses with flat washers (not provided). Do not use old hoses.

Both hoses must be attached and have water flowing to

inlet valves. If you are only connecting to a cold water

faucet, you must use a Y-adapter (not provided).

Connect inlet hoses to water

faucets

Attach hose to hot water faucet. Screw on coupling by hand

until it is seated on washer. Use pliers to tighten couplings an

additional two-thirds turn. Repeat this step with second hose

for cold water faucet.

IMPORTANT: Do not overtighten or use tape or sealants on

valve when attaching to faucets or washer. Damage can result.

HELPFUL TIP: Make note of which hose is connected to hot

water to help in attaching hoses to washer correctly. In most

standard configurations, hoses will cross over each other when

attached correctly.

Clear water lines

Run water for a few seconds through hoses into a laundry tub,

drainpipe or bucket to prevent clogs. Water should run until

clear.

10.

Connect inlet hoses to washer

Attach hot water hose to hot water inlet valve marked with a red

ring. Screw coupling by hand until it is snug. Use pliers to tighten

couplings an additional two-thirds turn. Repeat with cold water

inlet valve.

IMPORTANT: To reduce risk of hose failure, replace the hoses

every 5 years. Record hose installation or replacement dates for

future reference.

n Periodically inspect and replace hoses if bulges, kinks, cuts,

wear, or leaks are found.

11.

Check for leaks

Turn on water faucets to check for leaks. A small amount of

water may enter washer. It will drain later.