Whirlpool Cabrio,- WED7300X Panduan Penggunaan dan Perawatan - Halaman 5

Halaman Cetak

Whirlpool Cabrio,- WED7300X Panduan Penggunaan dan Perawatan

CYCLE SIGNAL

Use this option to adjust volume of the signal that sounds

at end of cycle. You may select Loud, Soft, or OFF (no

indicator lit). A louder signal is helpful in removing items

as soon as cycle is complete.

To turn button sounds on or off:

Press and hold Cycle Signal for 3 seconds to turn the

button sounds off or on.

EST TIME REMAINING DISPLAY

The Estimated Time Remaining display shows the time

required for the cycle to complete. Factors such as load size

and water pressure may affect the time shown in the display.

Overloading, unbalanced loads, or excessive suds may

cause the washer to adjust the cycle time, as well.

CYCLE STATUS LIGHTS INDICATOR

The Cycle Status Lights shows the progress of a cycle. At

each stage of the process, you may notice sounds or pauses

that are different from traditional washers.

SENSING

When the START/Pause/Unlock button is pressed,

the washer will first perform a self-test on the lid lock

mechanism. You will hear a click, the basket will make

a slight turn, and the lid will unlock briefly before

locking again.

Once the lid has locked the second time, the washer

will slowly spin the dry load to estimate the load size and

amount of water needed, and begin adding water. The

washer will then move the load briefly, pause to allow

water to soak in to the load, and resume adding water.

This process may repeat until the correct amount of

water has been added for the load. You may also hear

water flowing through the dispenser, adding detergent

to the load.

NOTE: The sensing light may also come on during the

Soak and Wash portions of the cycle. This is normal.

SOAK

This portion of the cycle allows water to soak into the load

for optimal cleaning.

WASH

You will hear the washplate moving the load. Unlike

traditional washers, the load is not covered with water.

Low-water cleaning means concentrated cleaning.

Rather than diluting detergent as done in an agitator-style

washer, this washer delivers the detergent directly to the

soils. The motor sounds may change at different stages

in the cycle. The wash time is determined by the selected

soil level.

RINSE

You will hear sounds similar to the wash cycle as the washer

rinses and moves the load. Fabric softener will be added if the

Fabric Softener option was selected.

SPIN

The washer spins the load at increasing speeds for proper

water removal, based on the selected cycle and spin speed.

DONE

Once the cycle is complete, this light will come on.

Remove the load promptly for best results.

LID LOCK

To allow for proper load sensing, the lid will lock and the

Lid Lock light will turn on. This light indicates that the lid

is locked and cannot be opened.

If you need to open the lid, press

START/Pause/Unlock. The lid will unlock

once the washer movement has stopped.

This may take several minutes if the load

was spinning at high speed. Press

START/Pause/Unlock again to resume

the cycle.