Xerox WORKCENTRE C2424 Petunjuk Manual - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Printer Xerox WORKCENTRE C2424. Xerox WORKCENTRE C2424 6 halaman. Copier-printer
Juga untuk Xerox WORKCENTRE C2424: Panduan Referensi Cepat (14 halaman), Brosur (8 halaman), Panduan Tambahan (7 halaman), Spesifikasi (6 halaman), Panduan Pengguna (43 halaman), Panduan Memulai (26 halaman), Panduan Pengguna (21 halaman), Panduan Pengguna (20 halaman), Panduan Pemeliharaan (20 halaman), Panduan Pengguna (19 halaman), Petunjuk Manual (16 halaman), Manual (12 halaman), Panduan Instalasi (4 halaman), Panduan Instalasi (2 halaman), Penggantian Kit Rol Umpan (2 halaman), Setup Manual (2 halaman), Templat Aksesibilitas Produk Sukarela (10 halaman), Perbandingan Kompetitif (3 halaman), Panduan Referensi Cepat (14 halaman), Panduan Servis (11 halaman), Panduan Referensi Cepat (13 halaman)

Halaman Cetak

Follow all warnings and instructions marked on, or supplied with, the system, options and

■

supplies.

Caution

Use of other than Genuine Xerox WorkCentre C2424 Solid Ink may affect print and copy

quality and system reliability. It is the only ink designed and manufactured under strict

quality controls by Xerox for specific use with this system. The Xerox Warranty, Service

Agreements, and Total Satisfaction Guarantee do not cover damage, malfunction, or

degradation of performance caused by use of non-Xerox supplies or consumables, or the

use of Xerox supplies not specified for this system.

Note

The Total Satisfaction Guarantee is available in the United States and Canada.

Coverage may vary outside these areas; please contact your local representative for

details.

System Location

■

Place the system in a dust-free area within a temperature range of 50 degrees F to

90 degrees F (10 degrees C to 32 degrees C) and a relative humidity range of 10 percent to

80 percent.

Place the system in an area where there is adequate space for ventilation, operation, and

■

servicing. The recommended minimal spacing is:

■

30 cm (11.8 in.) above, measuring from the top of the document feeder

■

24 cm (9.5 in.) behind

■

10 cm (3.9 in.) on the left side of the system

■

37 cm (14.6 in.) on the right side of the system, to allow access to the maintenance

unit and waste tray.

Do not block or cover the slots and openings on the system. The system may overheat

■

without adequate ventilation.

■

For optimum performance, use the system at elevations below 2,438 m (8,000 ft.).

■

Do not place the system on a carpeted location such as a carpeted floor. Airborne carpet

fibers can be pulled into the system and cause print- and copy-quality problems.

■

Do not place the system near a heat source.

■

Do not place the system in direct sunlight.

■

Do not place the system in line with the cold air flow from an air conditioning system.

■

Place the system on a level, solid non-vibrating surface with adequate strength for the

weight of the system. It should be within 2 degrees of horizontal with all four feet in solid

contact with the surface. The base system weight without any packaging materials is

approximately 42 kg (93 lbs.).

WorkCentre® C2424 Copier-Printer

A-3