3D AEROWORKS TRACER 2000 Panduan Perakitan dan Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Perakitan dan Panduan Pengguna untuk Pesawat terbang 3D AEROWORKS TRACER 2000. 3D AEROWORKS TRACER 2000 19 halaman. Thermal glider

Halaman Cetak

Glue the rear section to the v-tail to the tube.

Place glue

(marked in green)

Glue the stabilisers to the center pieces.

Glue the tips to the stabilisers.

Run a 1mm drill bit through the control horn of the elevator to make sure the fishing

line will pass through easily.

Test fit the hinges to the control surfaces and to the stabilisers before gluing.

Note - when gluing hinges, make sure all excess CA glue is removed. Any excess will

cause the hinge to bind and be unusable.

and join the two sections of the v-tail together.