3D AEROWORKS TRACER 2000 조립 설명서 및 사용자 설명서 - 페이지 8
{카테고리_이름} 3D AEROWORKS TRACER 2000에 대한 조립 설명서 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D AEROWORKS TRACER 2000 19 페이지. Thermal glider
페이지 인쇄-
Glue the rear section to the v-tail to the tube.
-
Place glue
(marked in green)
-
Glue the stabilisers to the center pieces.
-
Glue the tips to the stabilisers.
-
Run a 1mm drill bit through the control horn of the elevator to make sure the fishing
line will pass through easily.
-
Test fit the hinges to the control surfaces and to the stabilisers before gluing.
Note - when gluing hinges, make sure all excess CA glue is removed. Any excess will
cause the hinge to bind and be unusable.
and join the two sections of the v-tail together.