3D AEROWORKS TRACER 2000 조립 설명서 및 사용자 설명서 - 페이지 9
{카테고리_이름} 3D AEROWORKS TRACER 2000에 대한 조립 설명서 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D AEROWORKS TRACER 2000 19 페이지. Thermal glider
페이지 인쇄5
Assembling the servo tray
-
Trim the servo arm down so that the fourth hole is the outermost hole.
-
Screw or hot glue the servos in place.
-
Glue the m6 nylon nuts in their slots in the underside of the servo tray.
-
Thread fishing line through the 4 holes at the rear of the tail and connect the ends to
the servo arms for both servo's. Place a drop of CA on the knot to secure it. Be sure to
leave plenty of excess to be attached to the elevators later on.