3D Hobby Shop 62 inch OSIRIS Panduan Perakitan - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Mainan 3D Hobby Shop 62 inch OSIRIS. 3D Hobby Shop 62 inch OSIRIS 14 halaman.

Once stabilizer is perfectly located, drip a generous amount of thin CA glue into the stabilizer-fuselage

joint on top and bottom. If you drip any CA onto your covering, use CA debonder and a towel to remove

unwanted glue from the covering material.

Assemble tailwheel bracket onto tailwheel wire. Drill hole just beneath bottom rudder hinge into rudder.

Install tailwheel wire into rudder as shown with 30 minute epoxy, allow to cure. Install wheel and collar

onto tailwheel wire.