3D Hobby Shop 62 inch OSIRIS Montageanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Montageanleitung für Spielzeug 3D Hobby Shop 62 inch OSIRIS herunter. 3D Hobby Shop 62 inch OSIRIS 14 Seiten.

Seite drucken
6
Once stabilizer is perfectly located, drip a generous amount of thin CA glue into the stabilizer-fuselage
joint on top and bottom. If you drip any CA onto your covering, use CA debonder and a towel to remove
unwanted glue from the covering material.
Assemble tailwheel bracket onto tailwheel wire. Drill hole just beneath bottom rudder hinge into rudder.
Install tailwheel wire into rudder as shown with 30 minute epoxy, allow to cure. Install wheel and collar
onto tailwheel wire.