3D Hobby Shop 62 inch OSIRIS 조립 설명서 - 페이지 6

{카테고리_이름} 3D Hobby Shop 62 inch OSIRIS에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 62 inch OSIRIS 14 페이지.

페이지 인쇄
6
Once stabilizer is perfectly located, drip a generous amount of thin CA glue into the stabilizer-fuselage
joint on top and bottom. If you drip any CA onto your covering, use CA debonder and a towel to remove
unwanted glue from the covering material.
Assemble tailwheel bracket onto tailwheel wire. Drill hole just beneath bottom rudder hinge into rudder.
Install tailwheel wire into rudder as shown with 30 minute epoxy, allow to cure. Install wheel and collar
onto tailwheel wire.