3D Hobby Shop 62 inch OSIRIS 조립 설명서 - 페이지 8
{카테고리_이름} 3D Hobby Shop 62 inch OSIRIS에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 62 inch OSIRIS 14 페이지.
페이지 인쇄8
Glue elevator joiner into one elevator half with thick CA or epoxy glue. Allow to cure.
Insert elevator half with joiner into stabilizer, install with two large drops of thin CA glue on each hinge.
Trail-fit second elevator half with no glue. Check for alignment between elevator halves. Correct joiner
slot in second elevator as necessary.
Install second elevator half, using thick CA or epoxy on joiner and two drops of thin CA on each hinge.