3D Hobby Shop 62 inch OSIRIS 조립 설명서 - 페이지 4
{카테고리_이름} 3D Hobby Shop 62 inch OSIRIS에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 62 inch OSIRIS 14 페이지.
페이지 인쇄4
Insert horizontal stabilizer into fuselage cutout. Do not glue at this time. NOTE: Do not remove any
covering from the horizontal stabilizer. Align side-to-side as shown.
Install carbon wing tube into fuselage and measure on both sides form tube to stabilizer, equalize these
measurements.