3Doodler Create+ Panduan Pengguna

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori 3Doodler Create+. 3Doodler Create+ 11 halaman.
Juga untuk 3Doodler Create+: Panduan Pengguna (16 halaman)

Halaman Cetak
3Doodler Create+ Panduan Pengguna
User Manual
WHAT'S INCLUDED

SECTION 1: WARNINGS

- The Nozzle of the 3Doodler Create+
can become hot. DO NOT touch
the Nozzle, or you may be burned!
- DO NOT allow the Nozzle near or in
contact with flammable materials.
- Inform others in the area that the Pen
is hot and should not be touched.
Unplug and set the Control Switch
to OFF when not in use or before
storing.
Allow the Nozzle to cool
completely before storing.
The Unblocking Tool can become
hot. DO NOT touch the metal part
of the Unblocking Tool after using
it to clean your 3Doodler Create+
or you may burn yourself!
ADULT USE ONLY. KEEP OUT OF REACH OF CHILDREN.
Disposal of this product
At the end of your 3Doodler Create+'s life, please do not dispose of it
in your general household waste. In order to prevent possible harm to
the environment or human health from uncontrolled waste disposal,
please dispose of your 3Doodler Create+ separately in accordance
with local laws and regulations.
02/2022
3Doodler
Create+ Pen
75 strands of
3Doodler 3mm
PLA Refills
Colors may vary
DO NOT use the 3Doodler Create+
near bathtubs, showers, basins or
other vessels containing water.
This could result in death due to
electric shock.
The 3Doodler Create+ should only be
used with 3Doodler Create+ plastic
filament. Misuse of your 3Doodler
Create+, setting your pen to the
wrong heating temperature, or use
of non-approved plastic filament
or other materials may result in
damage to your pen or injury to
you, and will void your warranty.
Injuries to the user may include, but
are not limited to, harm sustained
from inhaling substances that are
not suitable for heating; or burns
from flammable materials used in
the 3Doodler Create+.
For more information on the separate collection systems for waste
of electrical and electronic equipment, please contact your local
municipal authority. You can also contact the retailer from which
you purchased your 3Doodler Create+, who may have a recycling
program, or be part of a specific recycling scheme that you can use.
Unblocking
Tool
Power
Adapter
Nozzle
Spanner
WARNING: This 3D Printing
Device, when used with a styrene
filament (ABS / HIPS / or PC-ABS),
can expose you and others in the
same room to styrene, which is
a chemical known to the State of
California to cause cancer. For
more information, go to
www.P65Warnings.ca.gov.
ALWAYS OPERATE YOUR 3D
PRINTING DEVICE IN A WELL-
VENTILATED AREA.
1
EN