3Doodler Create+ Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori 3Doodler Create+. 3Doodler Create+ 11 halaman.
Juga untuk 3Doodler Create+: Panduan Pengguna (16 halaman)

Halaman Cetak

STEP 6:

Power Down

SECTION 3: TROUBLESHOOTING

Included Tools

Before showing you how to troubleshoot issues

with your 3Doodler Create+, we want to introduce

you to two handy tools included in the box:

Unblocking Tool

Used to push short plastic strands down into

the drive gear to help with extrusion, or to push

short plastic strands out of the back of the pen.

With those introductions over, let's look at some different issues that could arise with

your 3Doodler Create+ and steps to get back to Doodling.

02/2022

NOTE:

Plastic that is shorter than 5.3 inches cannot be reversed. You should feed it all the way

through your 3Doodler Create+ and use it up. Or you can push the plastic out the back of

the pen using your unblocking tool -

Remove any plastic strand

from the pen using the reverse

feature (double click either

speed button).

NOTE:

After 5 minutes of inactivity, the 3Doodler

Create+ heating system will automatically

power down. You will need to press either

speed button OR toggle the control switch

OFF and then ON again to continue use.

5.3

inches

See Section 3, Step

3B.)

Slide the control switch to OFF.

TAKE A BREAK:

We recommend powering down and giving

your 3Doodler Create+ a 30 minutes break

after every 2 hours of continuous use.

Mini Spanner

Used for tightening and removing

the nozzle.

Only remove the nozzle when

the pen is on and hot.

Do not over tighten the nozzle,

as you may break it.

SECTION 2: GETTING STARTED

Power Adapter

Unplug it from the power

source and allow your pen to

cool completely before storing.