3Doodler Create+ Panduan Pengguna - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori 3Doodler Create+. 3Doodler Create+ 11 halaman.
Juga untuk 3Doodler Create+: Panduan Pengguna (16 halaman)
Halaman Cetak
STEP 2:
Load and extrude
plastic
STEP 3:
Doodle your name
Use the box on page 4 to
create your first Doodle!
02/2022
1
PLA
Select one strand of
plastic (included in the box).
4
After 10-15 seconds, plastic
will begin extruding from the
nozzle. Extruded plastic will
harden after a few seconds.
1
Write your name in the box
provided using a marker, pen
or pencil. We suggest cursive,
with the letters connected.
3
Trace your name in a continuous
line by dragging the plastic
along the paper as if you were
writing with a pencil, with all
the letters connected. Keep your
movement slow and steady.
2
x1
Click either speed button
once and release. You will hear
the drive gear start.
5
x1
Click either speed button once
to stop extruding.
2
NOTE:
The pen tip must make contact with
the paper for it to stick.
Click either speed button once. When the plastic starts
extruding, push the nozzle down into paper to get the plastic to
stick to the surface.
4
x1
When you reach the end of your
name, stop extruding by clicking
either speed button once.
SECTION 2: GETTING STARTED
3
GREEN
Light
With the LED light GREEN,
insert the PLA strand into the
plastic loading port.
5
Bend the corners of your paper
to pop your Doodled name off
the page.
3
EN