ESI ESRTD5 Petunjuk Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Termostat ESI ESRTD5. ESI ESRTD5 16 halaman. Digital room thermostat with tpi & delayed start
Juga untuk ESI ESRTD5: Panduan Petunjuk Instalasi (12 halaman)

Halaman Cetak

1. Setting & adjusting the

thermostat

Setting the Temperature

1.1

To set the temperature, turn the dial until the desired tem-

perature is shown in the LED display. The LED display will flash

the desired temperature for (approximately) 5 seconds before

returning to display the current room temperature.

Setting TPI

1.2

TPI is usually set up during installation. To adjust the setting

after installation, simply click the unit off the backplate (See

section 2.1 for details) and move the DIP switch on the rear of

the unit to TPI (See section 4.2.3 for details). Refer to Section

2.2 to click the unit back into place.

Setting Delayed Start

1.3

Delayed Start is usually set up during installation. To adjust

the setting after installation, simply click the unit off the back-

plate (See section 2.1 for details) and move the DIP switch

on the rear of the unit to Delayed Start (See section 4.2.3 for

details). Refer to Section 2.2 to click the unit back into place.