ESI ESRTD5 Інструкція користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція користувача для Терморегулятор ESI ESRTD5. ESI ESRTD5 16 сторінок. Digital room thermostat with tpi & delayed start
Також для ESI ESRTD5: Інструкція з монтажу Посібник з монтажу (12 сторінок)

Друкувати сторінку

1. Setting & adjusting the

thermostat

Setting the Temperature

1.1

To set the temperature, turn the dial until the desired tem-

perature is shown in the LED display. The LED display will flash

the desired temperature for (approximately) 5 seconds before

returning to display the current room temperature.

Setting TPI

1.2

TPI is usually set up during installation. To adjust the setting

after installation, simply click the unit off the backplate (See

section 2.1 for details) and move the DIP switch on the rear of

the unit to TPI (See section 4.2.3 for details). Refer to Section

2.2 to click the unit back into place.

Setting Delayed Start

1.3

Delayed Start is usually set up during installation. To adjust

the setting after installation, simply click the unit off the back-

plate (See section 2.1 for details) and move the DIP switch

on the rear of the unit to Delayed Start (See section 4.2.3 for

details). Refer to Section 2.2 to click the unit back into place.