ESI ESRTD5 사용자 지침 - 페이지 6

{카테고리_이름} ESI ESRTD5에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ESI ESRTD5 16 페이지. Digital room thermostat with tpi & delayed start
ESI ESRTD5에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (12 페이지)

페이지 인쇄
ESI ESRTD5 사용자 지침
1. Setting & adjusting the
thermostat

Setting the Temperature

1.1
To set the temperature, turn the dial until the desired tem-
perature is shown in the LED display. The LED display will flash
the desired temperature for (approximately) 5 seconds before
returning to display the current room temperature.

Setting TPI

1.2
TPI is usually set up during installation. To adjust the setting
after installation, simply click the unit off the backplate (See
section 2.1 for details) and move the DIP switch on the rear of
the unit to TPI (See section 4.2.3 for details). Refer to Section
2.2 to click the unit back into place.

Setting Delayed Start

1.3
Delayed Start is usually set up during installation. To adjust
the setting after installation, simply click the unit off the back-
plate (See section 2.1 for details) and move the DIP switch
on the rear of the unit to Delayed Start (See section 4.2.3 for
details). Refer to Section 2.2 to click the unit back into place.
6