dji AGRAS MG-1 Panduan Memulai Cepat - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Drone dji AGRAS MG-1. dji AGRAS MG-1 19 halaman.
Juga untuk dji AGRAS MG-1: Panduan Pengguna (3 halaman)

Halaman Cetak

AGRAS MG-1

Quick Start Guide

Smart Operation

The aircraft will travel along pre-designated square zig zag route after the turning Points A and B have been

recorded. The altitude difference between the aircraft and vegetation is maintained under optimal working

conditions. The aircraft will spray liquid automatically while flying along the route and stop spraying liquid while

hovering at the turning points. The length of the dotted lines, which are called Operation Gaps, can be adjusted

in the PC Assistant. It is recommended to fly in Smart Operation Mode when the spray area is large and in a

rectangular shape.

......

Ensure that Flight Mode Switch on the remote controller is toggled to the "P" position and a strong GPS signal

is present. In addition, ensure that the Operation Mode Switch on the remote controller is toggled to the "M"

position.

1. Record Points A and B in Order

Fly the aircraft to the starting point, depicted as Point A (B), hover, and then press

Button A (B) on the remote controller. The Point A (B) LED on the Spraying Status Panel

will become solid green and the Aircraft Status Indicator will blink red (green) after the

starting points have been recorded.

Update Point B by flying the aircraft to a new position and record this position. Note that if a Point A has been

updated, then Point B is also required to be updated accordingly.

It is recommended to keep the direction of Point A to B parallel to one side of the rectangular spray area for

optimal effect.

2. Select the Route

Press Back Left Button C1 or Back Right Button C2 on the remote controller to select the

operating pattern. Press Back Left Button C1 for Route L and Back Left Button C2 for Route

R. The Orientation LED on the Spraying Status Panel will blink to show that the selection has

been made. The default route pattern is Route R, if no selection has been made.

3. Adjust the Aircraft Altitude

Adjust the aircraft altitude to the desired altitude by using the throttle stick before entering Smart Operation

Mode, and the Altitude Stabilization System will start working automatically and maintain the spraying distance

between the aircraft and the vegetation.

Instructions:

a. Fly the aircraft above the vegetation and adjust the spraying distance between the

aircraft and the vegetation.

b. Confirm the desired spraying distance by observing the Height LEDs on the Spraying

Status Panel.

The optimal detection range for the spraying distance is between 1.5 to 7 meters. Always operate the aircraft above

vegetation within this range while adjusting aircraft altitude.

Ideal spraying distance should fall within the working range (2-3.5 meters) for altitude stabilization.

Refer to the User Manual for more information about the working conditions of the Altitude Stabilization System.

Route L

......

Route R

- - - - Operation Gap

Turning Point

●

Legends