Alumax ProLine PL60 Panduan Petunjuk Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kandang Alumax ProLine PL60. Alumax ProLine PL60 9 halaman. Heavy frameless bypass bath enclosure

Halaman Cetak

Fixed Panel Installation - Install the "peel-and-stick" Wall Seal [EE]

on the wall side edge of the Fixed Panel. Orient it with the open

end to the inside of the enclosure. Lift the Fixed Panel and set it in

the Glass Clips with the edge as tight to the wall as possible. Loosen

the Set Screws in the wall mount sleeves and slide them over the Wall

Mount Blocks. Snug the Set Screws into the block (DO NOT TIGHTEN).

Loosen, but do not remove, the Glass Mount Screws and make sure the

Header Bar is still level, or has a slight tilt toward the door side. Small

adjustments in the Header Bar can be made with the Set Screws in the

Wall Mount Sleeves. Once you have the Header Bar set as you want

it, and the Fixed Panel positioned correctly, tighten the Wall Mount Set

Screws, then the Glass Mount Screws.

Door Panel Installation – Lift the Door Glass [R] and place the

rollers on the bar, making sure to get the bottom edge of the

Door Glass into the Center Guide. To adjust the Rollers, up or down, the

Door Glass will have to be removed and the Rollers taken off. Rotate

the Glass Insert to move the off-center hole to the top or bottom of the

hole in the Door Glass. Rotating the Glass Insert to the bottom position

will raise the Door Glass, rotating it to the top will lower it. Reinstall the

Door Glass and Rollers, if necessary. Install the Rollers that go under the

Header Bar, adjusting them so that they are as close to the bottom of

the bar as possible.

Page 8 of 9