Alumax ProLine PL60 Panduan Petunjuk Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kandang Alumax ProLine PL60. Alumax ProLine PL60 9 halaman. Heavy frameless bypass bath enclosure

Halaman Cetak

Seal Installation – Cut the Bulb Vinyl [FF] to the vertical length of

your Door Glass. Cut the Panel Seal [GG] to the length of the

door glass minus 4". Press the Bulb Vinyl on the strike side of the Door

Glass and the Panel Seal on the other, below the Header Bar. A small

amount of silicone can be used between the glass and seal if you like.

Set the Stops – Move the door to the closed position. Slide the

Stopper [BB] over until it touches the top roller on the strike side

of the door. Tighten the Stopper Set Screw [CC] with the bumper in the

up position. Move the door to the open position with the handle 1/4" -

1/2" from hitting the fixed panel. Slide the other stopper over until it just

touches the top roller on the fixed side of the door. Tighten the Stopper

Set Screw with the bumper in the up position.

Finishing Up – Make sure that all fasteners are tight. Clean all

exposed marks you made on the sill and walls of the shower stall.

Clean the glass panels.

Allow 24 hours for any silicone to completely cure, before using

your new Alumax Shower Door.

Page 9 of 9