CYP CH-506TX Panduan Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pemanjang CYP CH-506TX. CYP CH-506TX 13 halaman. Hdmi/ir/rs-232 over single cat5e/cat6 extender
Juga untuk CYP CH-506TX: Panduan Pengoperasian (16 halaman), Panduan Pengoperasian (16 halaman), Panduan Pengoperasian (9 halaman), Panduan Pengoperasian (16 halaman)

6. OPERATION CONTROLS AND FUNCTIONS

Front

IR2 Extender

RS232 In

IR1 Blaster

RS-232 In: Connect to a PC/laptop or RS-232 enabled device(with

supplied 3.5 mm phone jack to D-Sub 9 pin adaptor) for the

transmission of RS-232 commands.

IR2 Extender: Connect to the supplied IR extender cable for IR

signal reception. Ensure that remote controller being used is within

the direct line-of-sight of the IR extender.

IR1 Blaster: Connect to the supplied IR blaster cable for IR signal

transmission. Place the IR blaster in direct line-of-sight of the

equipment to be controlled.

HDMI In: Connect to HDMI source equipment such as a DVD or Blu-

ray player.

DC 5V: Plug the 5 V DC power supply into the unit and connect the

adaptor to an AC outlet.

Link: The yellow LED will illuminate when both the input and output

CAT5e/6 signals are connected.

Power: This green LED will illuminate when the device is connected

to a power supply.

CAT5e/6 Out: Connect to the receiver unit with a single CAT5e/6

cable for transmission of all data signals.

HDMI In

Rear

DC 5V

Power

Link

CAT 5e /6 Out