CYP CH-506TX Kullanım Kılavuzu - Sayfa 7

Genişletici CYP CH-506TX için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. CYP CH-506TX 13 sayfaları. Hdmi/ir/rs-232 over single cat5e/cat6 extender
Ayrıca CYP CH-506TX için: Kullanım Kılavuzu (16 sayfalar), Kullanım Kılavuzu (16 sayfalar), Kullanım Kılavuzu (9 sayfalar), Kullanım Kılavuzu (16 sayfalar)

Sayfayı Yazdır
CYP CH-506TX Kullanım Kılavuzu

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Transmitter Front and Rear Panels

Front
IR2 Extender
RS232 In
IR1 Blaster
1
2
1
RS-232 In: Connect to a PC/laptop or RS-232 enabled device(with
supplied 3.5 mm phone jack to D-Sub 9 pin adaptor) for the
transmission of RS-232 commands.
2
IR2 Extender: Connect to the supplied IR extender cable for IR
signal reception. Ensure that remote controller being used is within
the direct line-of-sight of the IR extender.
3
IR1 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line-of-sight of the
equipment to be controlled.
4
HDMI In: Connect to HDMI source equipment such as a DVD or Blu-
ray player.
5
DC 5V: Plug the 5 V DC power supply into the unit and connect the
adaptor to an AC outlet.
6
Link: The yellow LED will illuminate when both the input and output
CAT5e/6 signals are connected.
7
Power: This green LED will illuminate when the device is connected
to a power supply.
8
CAT5e/6 Out: Connect to the receiver unit with a single CAT5e/6
cable for transmission of all data signals.
3
HDMI In
3
4
Rear
DC 5V
Power
Link
5
6
7
CAT 5e /6 Out
8