ACR Electronics RCL-75 Panduan Dukungan Produk - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Dukungan Produk untuk Lampu Banjir ACR Electronics RCL-75. ACR Electronics RCL-75 20 halaman. Remote control searchlight system
Juga untuk ACR Electronics RCL-75: Panduan Dukungan Produk (15 halaman), Panduan Dukungan Produk (20 halaman)
Halaman Cetak
When the flush mount option is selected, cut a rectangular hole in the
dashboard location using the Point Pad™ Flush Mount Template
supplied in the Mounting Templates. Use the gasket, washers, nuts, and
the two U-Clamps provided to secure the Point Pad™. Use a sealant
around the cut out to protect from moisture intrusion.
Make sure there are no obstructions behind the area where the switch is
to be located. (i.e. bulkheads, wires, plumbing, hardware.) Check in
advance to verify the wiring harness can be routed to this location.
Figure 4-
Figure 5-
Point Pad™ surface mount
Point Pad™ flush mount
Mounting the Light
Make sure area is clean and dry. Decide on the use of screws or bolts.
Verify that the backside of the mounting surface can be reached to
install nuts and washers.
NOTE: If the mounting surface is not flat, a special, shapeable plate can
be purchased, (P/N 9427), to adapt the light base to the surface. This
plate can also be used to raise the light 1 inch (2.54 cm) if desired (see
Figure 6).
Y1-03-0158G
8