ACR Electronics RCL-75 제품 지원 매뉴얼 - 페이지 9

{카테고리_이름} ACR Electronics RCL-75에 대한 제품 지원 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Electronics RCL-75 20 페이지. Remote control searchlight system
ACR Electronics RCL-75에 대해서도 마찬가지입니다: 제품 지원 매뉴얼 (15 페이지), 제품 지원 매뉴얼 (20 페이지)

페이지 인쇄

When the flush mount option is selected, cut a rectangular hole in the

dashboard location using the Point Pad™ Flush Mount Template

supplied in the Mounting Templates. Use the gasket, washers, nuts, and

the two U-Clamps provided to secure the Point Pad™. Use a sealant

around the cut out to protect from moisture intrusion.

Make sure there are no obstructions behind the area where the switch is

to be located. (i.e. bulkheads, wires, plumbing, hardware.) Check in

advance to verify the wiring harness can be routed to this location.

Figure 4-

Figure 5-

Point Pad™ surface mount

Point Pad™ flush mount

Mounting the Light

Make sure area is clean and dry. Decide on the use of screws or bolts.

Verify that the backside of the mounting surface can be reached to

install nuts and washers.

NOTE: If the mounting surface is not flat, a special, shapeable plate can

be purchased, (P/N 9427), to adapt the light base to the surface. This

plate can also be used to raise the light 1 inch (2.54 cm) if desired (see

Figure 6).

Y1-03-0158G