DORIC Electrical Rotary Joint Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di registrazione DORIC Electrical Rotary Joint. DORIC Electrical Rotary Joint 14.

1. Deposit the Holder ERJ frame on the base (1) and secure using #8-32 or M4 screws (2) and bolts (3) (Fig. 2.1a).

The holder can be installed in an experimental setup using 1/4 (or M6) screws and nuts.

2. Install the Electrical Rotary Joint in the Holder ERJ base (Fig. 2.1b) and secure it in place using the 3/4-32 UN secur-

ing bolt (Fig. 2.1c).

3. The 1x1 Fiber-optic Rotary Joint must ﬁrst be set up in the Holder FRJ small, using the directives in the 1x1 Fiber-

optic Rotary Joint User Manual, to be installed. The Holder FRJ small is then be attached to the Holder ERJ frame (1)

using 1/4 (or M6) screws (2) and bolts (3) (Fig. 2.1d). See Figure

For installation using the 1x2 Fiber-optic Rotary Joint - Intensity division or the 1x2 Fiber-optic Rotary Joint - Wave-

length division, the rotary joint must ﬁrst be installed in the Holder FRJ large using the directives in the 1x2 Fiber-

optic Rotary Joint User Manual. The Holder FRJ large is then attached to the frame in the same fashion as with an

1x1 Fiber-optic Rotary Joint. See Figure

(a) With 1x1 Fiber-optic Rotary Joint

Chapter 2. Operations Guide

2.2a

2.2b

for the ﬁnal result.

(b) With 1x2 Fiber-optic Rotary Joint - Intensity

division

Figure 2.2: Holder ERJ

for the ﬁnal result.