Andersen 618803 Manuale di installazione della maniglia - Pagina 2
Sfoglia online o scarica il pdf Manuale di installazione della maniglia per Sistema di apertura della porta Andersen 618803. Andersen 618803 5.
Stampa la pagina
7/8" Machine Pan Painted
1" SMS Pan
STEP 1: INSTALL HANDLE SET
1" SMS Pan Painted
RIGHT
1" Machine Pan Painted
HANDED
1-1/2" Machine Flathead
A
Exterior
#10
1-1/2" Machine Flathead
2" SMS Pan Painted
Interior
#12
Slider
5/8" SMS Pan Painted
NOTE: Trim plates should not be installed
on door while completing below
1.
Insert handle without spindle into
exterior trim plate (with Andersen logo)
in downward position and rotate slightly
to secure it.
2.
Repeat for other handle and interior trim
plate.
STOP: Laminated Fixed Glass Doors only.
Slider must be replaced. See Interior Trim
Plate Kit for further instruction.
C2
1.
Rotate the handles into a vertical position.
2.
Install exterior and interior trim plates
together using two 1 1/2" pan head
screws onto the door. Spindle will pass
through the square hole in the lock case
and into the other handle.
3.
Rotate handle to a horizontal position.
1" SMS Pan
1" SMS Pan Painted
1" SMS Pan Painted
1" Machine Pan Painted
1" Machine Pan Painted
TOOLS NEEDED
1-1/2" Machine Flathead
1-1/2" Machine Flathead
#10
#10
1-1/2" Machine Flathead
B
1-1/2" Machine Flathead
2" SMS Pan Painted
2" SMS Pan Painted
#12
#12
5/8" SMS Pan Painted
5/8" SMS Pan Painted
1.
Check orientation of the lock case by
steps.
looking into the handle holes.
2.
If notch is facing away from the glass
panel as seen above, proceed to Step C1.
3.
If the notch is pointed downwards, proceed
to Step C2.
D
Interior
1.
Install lock case trim plate onto the edge
of the door and fasten with one 5/8"
screw. Do not overtighten.
2.
Insert dead bolt key cylinder into lock
case. Turn thumb latch to ensure proper
installation. Fasten with one 1 1/2"
flathead screw. Do not overtighten.
NOTE: Slider feature will function only on
doors featuring Quick Change System.
5/8"
1 1/2"
1 1/2"
Exterior
Interior
1
Slider
Dead
bolt key
2
cylinder
with thumb
latch
2
Flathead screw
x 2 Pan head screws
C1
2
2
1.
Rotate the handles into a horizontal
position.
2.
Install exterior and interior trim plates
together using two 1 1/2" pan head
screws onto the door. Spindle will pass
through the square hole in the lock case
and into the other handle.
3.
Proceed to Step D.
Interior