Bendix CVS SmarTire TPMS Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Strumenti di misura Bendix CVS SmarTire TPMS. Bendix CVS SmarTire TPMS 12.

Stampa la pagina

1. Troubleshooting

6. PROGRAMMING SENSOR ID CODES

USING THE DASH DISPLAY AND THE TOOL

IMPORTANT

As stated earlier, it is important to make sure that

there is no loss of power to the SmarTire

during the Learn Sensor procedure.

Note: Not all functionality may be accessible using the

dash display; if a menu item shown here is not visible on

your display, it may be disabled, or not available because

of the version of dash display being used. Use the Bendix

ACom

Diagnostic software for access to full functionality.

TPMS Ready

Left

(typical action:

"scroll down")

For systems that are configured to require a password:

Press and hold the center button for two seconds and

the display will show a password entry screen.

To enter a password, press the left button to scroll

the first digit from 9 to 0. When the correct digit is

displayed, press the right button to move to the

next digit in sequence. Repeat this action until all

four digits are entered correctly and then push the

right button to enter the password. If the password

is correct, the display will enter Setup Mode. If the

password is incorrect, the display will indicate that

the wrong password was entered and return to the

password entry screen.

NOTE: If the system is not configured to use a password,

the system will go directly to the setup mode.

TPMS

This icon is only

displayed when

Trailer TMPS is

detected

Right

(typical action:

"scroll across")

Center

(typical action: "select")

To enter the Setup Mode, on the dash display press the

center button repeatedly until the TPMS Ready screen

is displayed.

Above: With no active Diagnostic Trouble Codes (DTCs).

Above: If there are any active pressure or temperature

DTCs present, a symbol with an exclamation point inside

a triangle will be displayed.

When in Setup Mode, scroll to the "Learn Sensors" menu

item. Press the right button to select the Learn Sensor

function.

Depending on the version of the display installed, the

following screen may vary.

In cases where the "Learn All Tires" option is not shown,

the vehicle has an older version of the dash display, and

the technician will have to repeat Section 6.1 as many

times as needed to learn the missing tire IDs.

Go to 6.1

Go to 6.2