Bendix CVS SmarTire TPMS Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Strumenti di misura Bendix CVS SmarTire TPMS. Bendix CVS SmarTire TPMS 12.
Stampa la pagina6.1 TO HAVE THE SYSTEM LEARN A SINGLE
TIRE POSITION
IMPORTANT
As stated earlier, it is important to make sure that
there is no loss of power to the SmarTire
during the Learn Sensor procedure.
6.1.1 Press the right button on the dash display to select
the learn single tire option. The display will now
show the first axle on the vehicle. Press the left
button to scroll through the axles, and then use the
right button, if necessary, to scroll until the desired
tire is selected. Then press and hold the center
button for two seconds.
6.1.2 The next screen displayed will depend on the
display and receiver versions installed.
Select the Hand Tool option (scroll down using the
left button, then the right button to select it).
Earlier versions of software may instead take you
directly to the next step.
6.1.3 The screen will then show "Deleting Tire" and the
selected wheel position will flash.
6.1.4 When the ID for the selected tire has been deleted,
the screen will show "Learn in Progress".
6.1.5 The technician has three (3) minutes to use the
SmarTire Low Frequency (LF) Tool to send a
request to the sensor inside that tire, to transmit
its ID.
To do this, hold the SmarTire LF tool with the
transmission end pointed towards the tire's sidewall
adjacent to sensor's location approximately two (2)
®
TPMS
inches away from the tire's surface. Press and
release the Initiate/Learn (
will be heard) and keep the tool in place for
five (5) seconds until four (4) quick beeps are heard.
Note: Do not hold down the Initiate/Learn (
6.1.6 After the receiver registers the transmission, it can
take up to 30 seconds for the learn process to be
completed. Look for the "Learn Complete" screen
to be displayed.
IMPORTANT: Press the center button once to save
the changes and exit the "Learn" function.
Press the center button repeatedly to exit the Setup
Mode.
Potential error messages are:
Learn Time Out. This may occur when the three (3)
minute window for receiving the response from the sensor
is exceeded.
Duplicate Sensor ID. When the ID code received is
already being used on the vehicle.
See the Troubleshooting Section (Section 7) for more
information.
7
) Button (a single beep
LEARN COMPLETE
) button.