Bendix CVS SmarTire TPMS Manuale d'uso - Pagina 8
Sfoglia online o scarica il pdf Manuale d'uso per Strumenti di misura Bendix CVS SmarTire TPMS. Bendix CVS SmarTire TPMS 12.
Stampa la pagina6.2 TO HAVE THE SYSTEM LEARN
ALL THE TIRE POSITIONS
IMPORTANT
As stated earlier, it is important to make sure that
there is no loss of power to the SmarTire
during the Learn Sensor procedure.
To learn all tire positions, follow the steps under Section 6
above, but instead of selecting the "Learn Single Tire"
option, use the "Learn All Tires" option instead. (The
display may vary.)
When learning all tire positions, the display will expect
the responses from the tire sensors be received starting
with the front left tire and moving around the vehicle in a
counterclockwise pattern based upon the stored vehicle
configuration. (Note that a spare tire may also be included
in the tires to be identified).
Above tractors, below trailers
For dual tire axles, the inner tire is learned first and then
the outer tire. Follow the prompts on the display as it will
indicate the current position to be learned.
6.2.1 The next screen will permit you to select the "Hand
Tool" option. (The display may vary.)
These instructions will cover the use of the hand
tool to program the sensor IDs. For details about
the Manual ID entry option, please see BW2799.
6.2.2 The next screen will prompt you to choose to
overwrite the existing profile.
®
TPMS
Select "Yes" (press the right button) to continue.
The "Initializing Profile" screen will display the
system's progress in erasing the old profile.
6.2.3 Wait for the status bar to compete and the "Learn
in Progress" message to be displayed before
continuing.
The ID for the wheel position to be programmed will
be displayed next and the SmarTire Low Frequency
(LF) Tool must be used at that location within three
(3) minutes.
6.2.4. Use the technique described in 6.1.5 to request the
sensor to transmit its ID to the receiver.
6.2.5 Check that the "Learn Complete" has been
displayed (this may take up to 30 seconds) and
then move to the next tire position to be learned.
Repeat these steps until all wheel positions are
programmed.
6.2.6 IMPORTANT: Press the center button once to save
the changes and exit the "Learn" function.
Press the center button repeatedly to exit the Setup
Mode.
Potential error messages are:
Learn Time Out. This may occur when the three (3)
minute window for receiving the response from the sensor
is exceeded.
Duplicate Sensor ID. When the ID code received is
already being used on the vehicle.
See the Troubleshooting Section (Section 7) for more
information.
8
LEARN COMPLETE