Benedini TBS Mini Manuale - Pagina 5
Sfoglia online o scarica il pdf Manuale per Apparecchiature di registrazione Benedini TBS Mini. Benedini TBS Mini 11. Digital multifunctional rc-soundunit
Anche per Benedini TBS Mini: Manuale (11 pagine), Manuale dei dati tecnici (11 pagine)
Stampa la pagina
First setup
Important:
! Watch safety aspects at the end of this manual before first flight !
The TBS Mini is delivered full programmed and ready to run, according to your order.
It MUST only be teached to the radio!
The set control mode of the TBS Mini is checked at the first page of this manual.
Please see the following chapters how to teach the Mini according to the set control mode:
Encoder:
Direct sound selection:
Indirect sound selection:
Autostart:
!! Any changes on the sound system should be made AFTER the first setup was successfully !!
Remote volume control
If "Encoder" or "Indirect sound selection" control mode is used, the volume can be set from the
transmitter.
Standard setting:
Operation:
Select the desired function and KEEP it triggered → Volume changes
If the desired volume is reached, release the trigger button.
3. Control modes
3.1. Encoder (12-Key coder)
The most comfortable way of controlling the sound unit is using the so called "12-position
encoder". It consists of a 12 position rotary switch in combination with a push button. The desired
sound is selected by the rotary switch and is triggered by the push button.
The encoder is mounted in your transmitter and connected at a spare proportional channel.
It is optional and must be ordered separately!
After installation you should test the encoder by a common servo at the according receiver channel.
Keep the encoder push button pressed and move the rotary switch through all positions. The
attached servo must move to a new position at each rotary switch position. The total movement of
the servo should be about the same as at a normal joystick channels set to 100% travel.
Rotary switch for
sound selection
Connect to spare prop.
trigger switch
Channel of your TX.
TBS Mini, 05/2016
Page: 5
Page: 7
Page: 8
Page: 9
Funktion Nr. 11: Volume up
Nr. 12: Volume down
The total resistance of the encoder can be
adjusted to your TX by two solder bridges at
the rear side of the encoder pcb:
BOTH bridges
open
closed
www.benedini.de
Total resistance
app. 22 KOhm
app. 5 KOhm
Page 5 of 11