Dynojet power commander III Manuale di installazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di installazione per Automobile Accessories Dynojet power commander III. Dynojet power commander III 3. 2004 kawasaki zx12r
Anche per Dynojet power commander III: Istruzioni per l'installazione (5 pagine), Istruzioni per l'installazione (5 pagine), Istruzioni per l'installazione (4 pagine), Manuale di installazione (3 pagine), Istruzioni per l'installazione (4 pagine), Manuale di istruzioni per l'installazione (3 pagine), Istruzioni per l'installazione (3 pagine), Istruzioni per l'installazione (3 pagine), Istruzioni per l'installazione (3 pagine)

Stampa la pagina
Dynojet power commander III Manuale di installazione
Grey wire
i426-411
www.powercommander.com
Wire tap
Ground wire
6
Crimp the supplied wire tap to the
WHITE wire of the ECU (Fig. D).
This wire is from the smaller of the
two ECU connectors in position 5.
Note:The wire location is numbered
on the back of the connector ..
7
Connect the GREY wire from the
PCIII to the wire tap (Fig. E).
Note:
It is recommended to use dielectric
grease on both of these connections.
8
Attach the ground wire from the PCIII
to the negative side of the battery
(Fig. E).
9
Install the PCIII to the top, rear part
of the ECU using the supplied velcro
(Fig. F).
Make sure to use the alcohol
swab to clean both surfaces before
attaching velcro.
Tuning Notes:
This bike uses a fly-by wire system, so conven-
tional tuning can not be performed for all RPM
and throttle ranges.
The GREY wire from the PCIII is attached to the
throttle blade angle sensor of the throttle bodies
which is NOT directly correlated to the throttle
grip position.
Because of this when setting the
throttle position in the PCIII software we recom-
mend on resetting only the closed position after
the bike has completely warmed up.
arrow key (<) next to CLOSED to perform this
step and then click OK.
OPEN position unless you are on a dyno and
above 9000rpm.
You will notice that in the maps there are not
detailed values below 7000rpm at 100% throttle
and below 5250rpm at 60-80%.
the throttle blades will not open more than 60%
below this RPM range no matter how much throt-
tle input is given.
Therefore this area can not be
tuned.
2007 Yamaha YZF R1- PCIII USB - 3
Use the
Do not try to set the
This is because