Dynojet power commander III Panduan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Mobil Dynojet power commander III. Dynojet power commander III 3 halaman. 2004 kawasaki zx12r
Juga untuk Dynojet power commander III: Petunjuk Instalasi (5 halaman), Petunjuk Instalasi (5 halaman), Petunjuk Instalasi (4 halaman), Panduan Instalasi (3 halaman), Petunjuk Instalasi (4 halaman), Panduan Petunjuk Instalasi (3 halaman), Petunjuk Pemasangan (3 halaman), Petunjuk Instalasi (3 halaman), Petunjuk Pemasangan (3 halaman)

Halaman Cetak

Dynojet power commander III Panduan Instalasi

Grey wire

i426-411

www.powercommander.com

Wire tap

Ground wire

Crimp the supplied wire tap to the

WHITE wire of the ECU (Fig. D).

This wire is from the smaller of the

two ECU connectors in position 5.

Note:The wire location is numbered

on the back of the connector ..

Connect the GREY wire from the

PCIII to the wire tap (Fig. E).

Note:

It is recommended to use dielectric

grease on both of these connections.

Attach the ground wire from the PCIII

to the negative side of the battery

(Fig. E).

Install the PCIII to the top, rear part

of the ECU using the supplied velcro

(Fig. F).

Make sure to use the alcohol

swab to clean both surfaces before

attaching velcro.

Tuning Notes:

This bike uses a fly-by wire system, so conven-

tional tuning can not be performed for all RPM

and throttle ranges.

The GREY wire from the PCIII is attached to the

throttle blade angle sensor of the throttle bodies

which is NOT directly correlated to the throttle

grip position.

Because of this when setting the

throttle position in the PCIII software we recom-

mend on resetting only the closed position after

the bike has completely warmed up.

arrow key (<) next to CLOSED to perform this

step and then click OK.

OPEN position unless you are on a dyno and

above 9000rpm.

You will notice that in the maps there are not

detailed values below 7000rpm at 100% throttle

and below 5250rpm at 60-80%.

the throttle blades will not open more than 60%

below this RPM range no matter how much throt-

tle input is given.

Therefore this area can not be

tuned.

2007 Yamaha YZF R1- PCIII USB - 3

Use the

Do not try to set the

This is because