Dynojet power commander III 설치 매뉴얼 - 페이지 3

{카테고리_이름} Dynojet power commander III에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynojet power commander III 3 페이지. 2004 kawasaki zx12r
Dynojet power commander III에 대해서도 마찬가지입니다: 설치 지침 (5 페이지), 설치 지침 (5 페이지), 설치 지침 (4 페이지), 설치 매뉴얼 (3 페이지), 설치 지침 (4 페이지), 설치 지침 매뉴얼 (3 페이지), 설치 지침 (3 페이지), 설치 지침 (3 페이지), 설치 지침 (3 페이지)

페이지 인쇄

Grey wire

i426-411

www.powercommander.com

Wire tap

Ground wire

Crimp the supplied wire tap to the

WHITE wire of the ECU (Fig. D).

This wire is from the smaller of the

two ECU connectors in position 5.

Note:The wire location is numbered

on the back of the connector ..

Connect the GREY wire from the

PCIII to the wire tap (Fig. E).

Note:

It is recommended to use dielectric

grease on both of these connections.

Attach the ground wire from the PCIII

to the negative side of the battery

(Fig. E).

Install the PCIII to the top, rear part

of the ECU using the supplied velcro

(Fig. F).

Make sure to use the alcohol

swab to clean both surfaces before

attaching velcro.

Tuning Notes:

This bike uses a fly-by wire system, so conven-

tional tuning can not be performed for all RPM

and throttle ranges.

The GREY wire from the PCIII is attached to the

throttle blade angle sensor of the throttle bodies

which is NOT directly correlated to the throttle

grip position.

Because of this when setting the

throttle position in the PCIII software we recom-

mend on resetting only the closed position after

the bike has completely warmed up.

arrow key (<) next to CLOSED to perform this

step and then click OK.

OPEN position unless you are on a dyno and

above 9000rpm.

You will notice that in the maps there are not

detailed values below 7000rpm at 100% throttle

and below 5250rpm at 60-80%.

the throttle blades will not open more than 60%

below this RPM range no matter how much throt-

tle input is given.

Therefore this area can not be

tuned.

2007 Yamaha YZF R1- PCIII USB - 3

Use the

Do not try to set the

This is because