Bristan Opac TS1503 Istruzioni per l'installazione e manuale d'uso - Pagina 11
Sfoglia online o scarica il pdf Istruzioni per l'installazione e manuale d'uso per Unità di controllo Bristan Opac TS1503. Bristan Opac TS1503 20. Thermostatic shower valves
Stampa la paginaInstallation
1. Prepare the 15mm water pipework,
leaving sufficient pipe protruding
from the finished wall to fit
into the elbows.
Flush through the pipework
to ensure removal of any debris.
Turn off the mains water supply
and close any isolating valves.
Important: Water supplies to the mixer
must be with hot on the left and cold on
the right when viewed from the front.
2. Measure the centre distance. Measure
the half-way point between the centres
and mark on the wall.
3. Configure the inlet elbows to
meet the centre distance. Check the
Specification page for measurements.
Configuring the Inlet Elbows:
The shower valve is supplied with two
adjustable elbows. The elbows can be
pointed to feed from the top, bottom
or rear.
Two full turns are required to fit the
elbows into the body properly.
This will fit the elbows at their
maximum centre distance.
OP TS1503 SCL C – 125-132mm adjustable
centres.
TS1503ECP-2000-MK - 138-145mm
adjustable centres.
Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.
REMEMBER
Fit isolation
valves to pipe-
Hot
work for future
maintenance.
To Adjust Elbows:
1. Unscrew both inlet elbows
anti-clockwise from the valve body.
2. Screw in the desired elbows clockwise
for two complete turns to fit. This will
set to largest possible centre
measurement.
3. The elbows can be screwed a maximum
of 1.5 turns after fitting for adjustment.
Screw further clockwise to reduce the
centre measurement; anti-clockwise to
increase.
Centre Distance
Cold
Backplate
Fixing
Holes
11