Bristan Opac TS1503 Istruzioni per l'installazione e manuale d'uso - Pagina 12
Sfoglia online o scarica il pdf Istruzioni per l'installazione e manuale d'uso per Unità di controllo Bristan Opac TS1503. Bristan Opac TS1503 20. Thermostatic shower valves
Stampa la paginaInstallation
4. Undo the grub screws at the back of the
shower valve to remove the backplate.
Place the backplate on the marked
half-way point between the centres
and mark the fixing holes
5. Drill the fixing holes using a suitable drill
bit. A pilot drill will be required if drilling
into tiles. Insert the wall plugs and screw
the backplate to the wall.
Warning: Please check for any hidden
pipes and cables before
drilling holes into the wall.
TS1503ECP-2000-MK
OP TS1503 SCL C
Please refer to your specific shower kit instructions, or shower contents
sheet if a kit is supplied to install the shower kit. If your shower needs to follow the
TMV scheme, please refer to the TMV Manual to commission your shower.
12 Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.
6. Place the plinths over the water
supply pipes (TS1503ECP-2000-MK
only). Feed the shower valve on to the
water supply pipes and tighten with the
nuts and olives. Secure the valve to the
back plate using the grub screw.
7. OP TS1503 SCL C only: Use a hex key
to remove the handle from the valve.
Slide on the shroud cover until in clips
into the backplate. Secure in place with
the grub screws. Re-fit the handle in the
same position and secure with the
grub screw.