2N EasyGate Pro Avvio rapido - Pagina 2
Sfoglia online o scarica il pdf Avvio rapido per Porta d'ingresso 2N EasyGate Pro. 2N EasyGate Pro 4. Umts gateway
Anche per 2N EasyGate Pro: Avvio rapido (4 pagine), Avvio rapido (2 pagine), Avvio rapido (4 pagine)
Stampa la pagina
®
2N
EasyGate Pro UMTS Quick Start
• The primary purpose of 2N
(from now only 'Easy Gate') is to transmit voice
between a UMTS or GSM network and an
attached
analogue
connected to the FXS interface on the EasyGate.
• You
can
establish
send/receive SMS in combination with a PC.
Read the User Manual carefully to get familiar with all system functions at
wiki.2n.com.
EasyGate supports HSPA, UMTS, EDGE, GPRS and CSD technology for data
connection. The connection speed and quality depend on the mobile network
provider, accessible services, signal coverage and network status.
®
2N
EasyGate Pro UMTS Installation and Connection
• Proper Location
- Install EasyGate with respect to a good
mobile network signal strength.
- Place EasyGate out of range of sensitive
devices
and
electromagnetic interference reasons.
- EasyGate is designed for indoor use. Do not
place it near heat sources and on direct
solar radiation. It may not be exposed to
rain,
flowing
aggressive
• External Antenna Connection
Screw the antenna cord into the SMA
antenna connector. Tighten the antenna
connector gently with your hand, never
use a wrench!
• SIM Card Installation
Slot for SIM card is placed on the
connector panel. Insert the SIM card to
the slot according to the picture and make
sure that the card is locked properly.
Select the required GSM provider and SIM
card services, such as call forwarding, call
barring, preferred networks, SMS centre,
etc. using your mobile phone before
inserting your SIM card into EasyGate.
Do not activate the power supply until the antenna is connected to
EasyGate to avoid the UMTS module damage.
Basic Functions
®
EasyGate Pro UMTS
communication
data
connection
human
bodies
water
and
moisture,
gas,
solvents
• You can send an SMS to a pre-programmed
number using the SMS sending input.
• The battery backed-up EasyGate version
device
allows you to maintain your traffic even in the
event of power outage.
and
• Telephone Line Connection EasyGate
can be connected to any FXO-interface
equipment
answering machine, PBX CO line etc.).
for
EasyGate is equipped with identification of
calling party (CLIP) via FSK and so it is
advantageous to connect a terminal that is
able to display the CLI.
• Battery installation (battery backup
etc.
type)
Insert four pieces of rechargeable battery
NiMh
compartment on the back side of the
gateway. Refer to the compartment label
for proper battery placement and polarity.
Use mentioned type of batteries only!
• Mains Supply Connection and Switch
On
EasyGate is 12 V DC voltage powered.
Connect
(12 V / 1 A DC) to the power supply
connector. After connection, switch on
EasyGate with the power switch on the
right-hand side of connector panel (on
battery version only).
(standard
telephone
size
AA
into
the
attached
power
set,
the
covered
adapter