2N EasyGate Pro 빠른 시작 - 페이지 2

{카테고리_이름} 2N EasyGate Pro에 대한 빠른 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. 2N EasyGate Pro 4 페이지. Umts gateway
2N EasyGate Pro에 대해서도 마찬가지입니다: 빠른 시작 (4 페이지), 빠른 시작 (2 페이지), 빠른 시작 (4 페이지)

페이지 인쇄

EasyGate Pro UMTS Quick Start

• The primary purpose of 2N

(from now only 'Easy Gate') is to transmit voice

between a UMTS or GSM network and an

attached

analogue

connected to the FXS interface on the EasyGate.

• You

can

establish

send/receive SMS in combination with a PC.

Read the User Manual carefully to get familiar with all system functions at

wiki.2n.com.

EasyGate supports HSPA, UMTS, EDGE, GPRS and CSD technology for data

connection. The connection speed and quality depend on the mobile network

provider, accessible services, signal coverage and network status.

EasyGate Pro UMTS Installation and Connection

• Proper Location

- Install EasyGate with respect to a good

mobile network signal strength.

- Place EasyGate out of range of sensitive

devices

and

electromagnetic interference reasons.

- EasyGate is designed for indoor use. Do not

place it near heat sources and on direct

solar radiation. It may not be exposed to

rain,

flowing

aggressive

• External Antenna Connection

Screw the antenna cord into the SMA

antenna connector. Tighten the antenna

connector gently with your hand, never

use a wrench!

• SIM Card Installation

Slot for SIM card is placed on the

connector panel. Insert the SIM card to

the slot according to the picture and make

sure that the card is locked properly.

Select the required GSM provider and SIM

card services, such as call forwarding, call

barring, preferred networks, SMS centre,

etc. using your mobile phone before

inserting your SIM card into EasyGate.

Do not activate the power supply until the antenna is connected to

EasyGate to avoid the UMTS module damage.

Basic Functions

EasyGate Pro UMTS

communication

data

connection

human

bodies

water

and

moisture,

gas,

solvents

• You can send an SMS to a pre-programmed

number using the SMS sending input.

• The battery backed-up EasyGate version

device

allows you to maintain your traffic even in the

event of power outage.

and

• Telephone Line Connection EasyGate

can be connected to any FXO-interface

equipment

answering machine, PBX CO line etc.).

for

EasyGate is equipped with identification of

calling party (CLIP) via FSK and so it is

advantageous to connect a terminal that is

able to display the CLI.

• Battery installation (battery backup

etc.

type)

Insert four pieces of rechargeable battery

NiMh

compartment on the back side of the

gateway. Refer to the compartment label

for proper battery placement and polarity.

Use mentioned type of batteries only!

• Mains Supply Connection and Switch

EasyGate is 12 V DC voltage powered.

Connect

(12 V / 1 A DC) to the power supply

connector. After connection, switch on

EasyGate with the power switch on the

right-hand side of connector panel (on

battery version only).

(standard

telephone

size

into

the

attached

power

set,

the

covered

adapter