Fujitsu ETERNUS DX60 S2 Manuale di configurazione - Pagina 14

Sfoglia online o scarica il pdf Manuale di configurazione per Immagazzinamento Fujitsu ETERNUS DX60 S2. Fujitsu ETERNUS DX60 S2 16. Server connection. (fibre channel) for aix
Anche per Fujitsu ETERNUS DX60 S2: Manuale d'uso (35 pagine), Manuale d'uso (42 pagine), Manuale di configurazione (28 pagine), Manuale d'uso (14 pagine), Manuale di configurazione (38 pagine), Manuale di installazione hardware e software (36 pagine)

Chapter 2

Setting Up the ETERNUS DX

2.3

*2: When multiple ESX servers share ETERNUS DX LUNs, any ETERNUS DX CA port that connects a shared

LUN to an ESX server must be assigned to the same reset group, whether multi-paths are used for the

ESX servers or not.

Example: When multiple ESX servers share ETERNUS DX LUNs, CM#0 CA#0 Port#1 and CM#1 CA#0 Port#1

must be assigned to the same reset group, even for single-path configurations.

LAN switch#1

2.2.2

Setting the Subsystem Parameters (for HP-UX only)

Disable the [Load Balance] parameter in "Set Subsystem Parameters" screen. This prevents sense responses

that require access retries from being issued when the ETERNUS DX is overloaded.

For HP-UX server, improper logs may be recorded unless sense response is restricted. Therefore, "Load Bal-

ance" should be disabled. (Sense response should be restricted.)

Note that changing the "Load Balance" setting has no affect on non-HP-UX servers.

2.3

Checking the WWNs

Use ETERNUS Web GUI to check the WWN of each ETERNUS DX. They are required for connecting the ETERNUS

DX to the server.

Server#1

HBA#1

CM#0

Port#1

Affinity-Group

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

Server#2

HBA#1

LAN switch#2

CM#1

Port#1

P3AM-3182-15ENZ0