Fujitsu ETERNUS DX60 S2 구성 매뉴얼 - 페이지 14

{카테고리_이름} Fujitsu ETERNUS DX60 S2에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX60 S2 16 페이지. Server connection. (fibre channel) for aix
Fujitsu ETERNUS DX60 S2에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (42 페이지), 구성 매뉴얼 (28 페이지), 사용자 설명서 (14 페이지), 구성 매뉴얼 (38 페이지), 하드웨어 및 소프트웨어 설치 매뉴얼 (36 페이지)

Chapter 2

Setting Up the ETERNUS DX

2.3

*2: When multiple ESX servers share ETERNUS DX LUNs, any ETERNUS DX CA port that connects a shared

LUN to an ESX server must be assigned to the same reset group, whether multi-paths are used for the

ESX servers or not.

Example: When multiple ESX servers share ETERNUS DX LUNs, CM#0 CA#0 Port#1 and CM#1 CA#0 Port#1

must be assigned to the same reset group, even for single-path configurations.

LAN switch#1

2.2.2

Setting the Subsystem Parameters (for HP-UX only)

Disable the [Load Balance] parameter in "Set Subsystem Parameters" screen. This prevents sense responses

that require access retries from being issued when the ETERNUS DX is overloaded.

For HP-UX server, improper logs may be recorded unless sense response is restricted. Therefore, "Load Bal-

ance" should be disabled. (Sense response should be restricted.)

Note that changing the "Load Balance" setting has no affect on non-HP-UX servers.

2.3

Checking the WWNs

Use ETERNUS Web GUI to check the WWN of each ETERNUS DX. They are required for connecting the ETERNUS

DX to the server.

Server#1

HBA#1

CM#0

Port#1

Affinity-Group

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

Server#2

HBA#1

LAN switch#2

CM#1

Port#1

P3AM-3182-15ENZ0