Indesit Arcadia Manuale di servizio

Sfoglia online o scarica il pdf Manuale di servizio per Lavatrice Indesit Arcadia. Indesit Arcadia 3. Fault codes

Stampa la pagina

Service Quick Guide

FAULT

Main PCB, Triac on board damaged or

F01

components Feedback fault

Motor tripped, motor tachogenerator open

F02

circuit / or short circuit

F03

NTC wash sensor open / short circuit

1/3

SQG_WM_23/5_EN

Indesit Company, Service Department

Arcadia Fault Codes (Simple)

CAUSE

- Check for water leaks that may affect connectors J009 (Commuta-

- Check the motor terminal board (any problems due to aggression

- Check the connection on the wash heating element;

- Check efﬁ ciency of connector J001 (Commutator) or J010

- Check connector J001 (Commutator) or J010 (Three-phase)

- Check for water leaks that may affect connectors J006 (Commuta-

- Check the terminal board (any problems due to aggression

- Check wiring of connectors J006 (Commutator) or J007 (Three-

- Disconnect appliance for 2 minutes. Check wiring and connec-

- Check that correct operation has been restored by starting the

- Renew main PCB.

- Check for water leaks that may affect connector J9 causing the

- Check to ensure motor is not mechanically jammed or seized;

- Check efﬁ ciency of the contacts on connector J9 on the PCB;

- Check the motor side connector;

- Check motor winding and check that the impedance value on

- Check the tachogenerator winding and check that the impedance

- Check the tachogenerator wiring;

- Disconnect appliance for 2 minutes. Check that correct operation

- Renew motor;

- Renew PCB.

- Check efﬁ ciency of contacts on connector J005 (commutator)

- Check NTC ensuring that the impedance value at ambient

- If measurement is incorrect check continuity of wiring J005

- Check the same parameter directly on the NTC (20 KOhm);

- Renew NTC;

- Renew PCB.

SERVICE ACTIONS

tor) or J009 (Three-phase) causing the relative contacts to short;

caused by manufacturing chemical residues that may cause

short circuits);

(Three-phase) on the PCB;

pins 3 and 4 for continuity of the wash heating element (1700

watt - 230 volt) which must be 30 Ohm +/- 10%. Otherwise,

renew heating element;

tor) or J007 (Three-phase) causing the relative contacts to short;

caused by manufacturing chemical residues that may cause

short circuits);

phase)/Pressure switch;

tors of the dryer heating element on main PCB board side and

component side;

Autotest routine;

contacts to short circuit;

wiring connector J9 between pins 3 and 4, 4 and 5, 3 and 5 is

less than 100 Ohm;

value on wiring connector J9 between pins 1 and 2 is between

115 and 170 Ohm;

has been restored by starting the Autotest routine;

or J12 (three-phase) on PCB;

temperature (20°C) on wiring connector J005 (commutator) or

J12 (three-phase), pins 1 and 2, is approximately 20 KOhm;

(commutator) or J12 (three-phase), pins 1 and 2/NTC;