Indesit Arcadia Руководство по эксплуатации

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Стиральная машина Indesit Arcadia. Indesit Arcadia 3 страницы. Fault codes

Печатать страницу

Service Quick Guide

FAULT

Main PCB, Triac on board damaged or

F01

components Feedback fault

Motor tripped, motor tachogenerator open

F02

circuit / or short circuit

F03

NTC wash sensor open / short circuit

1/3

SQG_WM_23/5_EN

Indesit Company, Service Department

Arcadia Fault Codes (Simple)

CAUSE

- Check for water leaks that may affect connectors J009 (Commuta-

- Check the motor terminal board (any problems due to aggression

- Check the connection on the wash heating element;

- Check efﬁ ciency of connector J001 (Commutator) or J010

- Check connector J001 (Commutator) or J010 (Three-phase)

- Check for water leaks that may affect connectors J006 (Commuta-

- Check the terminal board (any problems due to aggression

- Check wiring of connectors J006 (Commutator) or J007 (Three-

- Disconnect appliance for 2 minutes. Check wiring and connec-

- Check that correct operation has been restored by starting the

- Renew main PCB.

- Check for water leaks that may affect connector J9 causing the

- Check to ensure motor is not mechanically jammed or seized;

- Check efﬁ ciency of the contacts on connector J9 on the PCB;

- Check the motor side connector;

- Check motor winding and check that the impedance value on

- Check the tachogenerator winding and check that the impedance

- Check the tachogenerator wiring;

- Disconnect appliance for 2 minutes. Check that correct operation

- Renew motor;

- Renew PCB.

- Check efﬁ ciency of contacts on connector J005 (commutator)

- Check NTC ensuring that the impedance value at ambient

- If measurement is incorrect check continuity of wiring J005

- Check the same parameter directly on the NTC (20 KOhm);

- Renew NTC;

- Renew PCB.

SERVICE ACTIONS

tor) or J009 (Three-phase) causing the relative contacts to short;

caused by manufacturing chemical residues that may cause

short circuits);

(Three-phase) on the PCB;

pins 3 and 4 for continuity of the wash heating element (1700

watt - 230 volt) which must be 30 Ohm +/- 10%. Otherwise,

renew heating element;

tor) or J007 (Three-phase) causing the relative contacts to short;

caused by manufacturing chemical residues that may cause

short circuits);

phase)/Pressure switch;

tors of the dryer heating element on main PCB board side and

component side;

Autotest routine;

contacts to short circuit;

wiring connector J9 between pins 3 and 4, 4 and 5, 3 and 5 is

less than 100 Ohm;

value on wiring connector J9 between pins 1 and 2 is between

115 and 170 Ohm;

has been restored by starting the Autotest routine;

or J12 (three-phase) on PCB;

temperature (20°C) on wiring connector J005 (commutator) or

J12 (three-phase), pins 1 and 2, is approximately 20 KOhm;

(commutator) or J12 (three-phase), pins 1 and 2/NTC;