EarthWay 2170 Manuale di istruzioni per il montaggio - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Spreader EarthWay 2170. EarthWay 2170 10. Commercial broadcast spreader with side spread control
Anche per EarthWay 2170: Manuale di montaggio e istruzioni per l'uso (6 pagine), Manuale di montaggio e istruzioni per l'uso (8 pagine), Manuale di istruzioni per l'uso (8 pagine), Manuale di istruzioni per il montaggio (12 pagine), Manuale di montaggio e istruzioni per l'uso (6 pagine)

Assembly and Operation Instructions

Places the bearings into the lower frame

Step 6:

using the "notch" on the bearing to fit into the

"notch" on the LOWER AXLE FRAME. Next slide the

axle through the bearings, through the GEAR BOX

and into the other LOWER AXLE FRAME. Next, install

AXLE BUSHING onto the axle, by placing the smaller

end in first, slide over the AXLE, past the drilled

holes.

NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.

Install DRIVE WHEEL onto the AXLE and align

Step 7:

with the cotter pin hole nearest to LOWER HANDLE as

shown. Insert 2" cotter pin through wheel and through

AXLE. Bend with pliers to prevent pin from falling out.

Install COAST WHEEL onto the AXLE fully, then

Step 8:

using outside cotter pin hole, insert 1" cotter pin through

AXLE (not thru the wheel). Bend with pliers to prevent

pin from falling out.

New for 2021 EarthWay listened to customers who desired an adjustable handle for taller operators.

Step 9:

Select three ¼" x 2" bolts and three nylon lock nut to complete this step.

Notice that the square handle shaft has two sets of holes in both ends. The end that the holes are closest to the end

of the handle shaft is the top. Place it as shown inbetween the handles.

Start by bolting through the handle spacer using the top most handle bar hole. Then bolt the gauge & lever assembly

through the two center holes using two of your ¼" x 2" bolts.

TIGHTEN ALL HARDWARE.

2170_M52164_RevJune2021

PAGE 4