EarthWay 2170 Manuale di istruzioni per il montaggio - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Spreader EarthWay 2170. EarthWay 2170 10. Commercial broadcast spreader with side spread control
Anche per EarthWay 2170: Manuale di montaggio e istruzioni per l'uso (6 pagine), Manuale di montaggio e istruzioni per l'uso (8 pagine), Manuale di istruzioni per l'uso (8 pagine), Manuale di istruzioni per il montaggio (12 pagine), Manuale di montaggio e istruzioni per l'uso (6 pagine)

Assembly and Operation Instructions

Take the shortest end of the PIVOT

Step 10:

ROD and insert into the SHUT-OFF PLATE. You

may have two holes, use the SHUT-OFF PLATE

hole towards the back of the spreader. Insert it

through the hole (downward) and then rotate 90

degrees so that end is turned parrellel as shown.

Through hole,

then rotate

X-SECTION SHUT

OFF PLATE

Locate the PIVOT ROD backet, insert

Step 11:

the other end of the PIVOT ROD through the back

of the PIVOT ROD BRACKET as shown (see

below).

Install HANDLE SHAFT to LOWER HANDLEs and PIVOT & BRACKET assembly as shown. Using 2" bolts and

Step 12:

locknuts. TIGHTEN BOLTS AND NUTS NOW.

Install flattened end of CONTROL ROD

Step 13:

in to LEVER on GAUGE as shown. Turn to lock in

place. Next push LEVER forward to setting "0".

Align CONTROL ROD with hole in PIVOT BRACKET,

pull LEVER backward to insert CONTROL ROD

through hole in PIVOT BRACKET.

Install (1) 1/4-20 regular nut (not a

Step 14:

locknut) on to CONTROL ROD as shown.

2170_M52164_RevJune2021

PAGE 6