Arcade ARC13 Istruzioni per l'installazione - Pagina 2
Sfoglia online o scarica il pdf Istruzioni per l'installazione per Prodotto idraulico Arcade ARC13. Arcade ARC13 5. Single lever bidet mixer with pop up waste
Stampa la paginaBeautifully
Traditional
INSTALLATION INSTRUCTIONS
Please read these instructions carefully and keep in a safe place for further reference.
General Installation Requirement
The installation must comply with regulations of the Local Water Authority as
contained in their bylaws. It will be necessary to fit non-return valves on both
the hot and cold feeds. It is very important that all pipework is flushed thoroughly
after installation to avoid impurities damaging the ceramic discs.
Minimum/Maximum working pressure
These taps are suitable for high and low pressure installations. They are fitted with
quarter turn ceramic disc headwork which provides a smooth movement.
The minimum work pressure is 0.2 bar. The maximum work pressure is 5 bar.
If the mains pressure is over 5 bar, a pressure reducing valve should be fitted.
Approvals
All taps are manufactured using materials tested and approved under the Water
Bylaws Scheme and comply with requirements of European standard EN200
where applicable.
Preparations and bylaw requirements
Water Bylaws require that where hot water is supplied from tank and cold from mains,
non return valves are fitted on both hot and cold pipes as close as possible to the tap.
These are not supplied. Where combination boilers are fitted, it is only necessary to
shut off the incoming mains and turn the boiler off. Non return valves are not required.
Warning
Before installing the new taps, it is essential that you thoroughly flush through the
supply pipes in order to remove any remaining swarf, solder or other impurities.
Failure to carry out this simple procedure could cause problems or damage to the
working of the taps.
These hints are prepared for your guidance; you must exercise due care at all times.
We do not accept responsibility for any problems that may occur through incorrect
installation.
2
Arcade single lever bidet mixer
with pop up waste
DIMENSIONS
Ø45
Ø65
NOTE: ALL DIMENSIONS IN MILLIMETRES
ARC13, ARC13 CHR
Ø35
148
www.arcadebathrooms.com
3