- ページ 2

配管製品 Arcade ARC13のPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Arcade ARC13 5 ページ。 Single lever bidet mixer with pop up waste

Beautifully

Traditional

INSTALLATION INSTRUCTIONS

Please read these instructions carefully and keep in a safe place for further reference.

General Installation Requirement

The installation must comply with regulations of the Local Water Authority as

contained in their bylaws. It will be necessary to ﬁt non-return valves on both

the hot and cold feeds. It is very important that all pipework is ﬂushed thoroughly

after installation to avoid impurities damaging the ceramic discs.

Minimum/Maximum working pressure

These taps are suitable for high and low pressure installations. They are ﬁtted with

quarter turn ceramic disc headwork which provides a smooth movement.

The minimum work pressure is 0.2 bar. The maximum work pressure is 5 bar.

If the mains pressure is over 5 bar, a pressure reducing valve should be ﬁtted.

Approvals

All taps are manufactured using materials tested and approved under the Water

Bylaws Scheme and comply with requirements of European standard EN200

where applicable.

Preparations and bylaw requirements

Water Bylaws require that where hot water is supplied from tank and cold from mains,

non return valves are ﬁtted on both hot and cold pipes as close as possible to the tap.

These are not supplied. Where combination boilers are ﬁtted, it is only necessary to

shut oﬀ the incoming mains and turn the boiler oﬀ. Non return valves are not required.

Warning

Before installing the new taps, it is essential that you thoroughly ﬂush through the

supply pipes in order to remove any remaining swarf, solder or other impurities.

Failure to carry out this simple procedure could cause problems or damage to the

working of the taps.

These hints are prepared for your guidance; you must exercise due care at all times.

We do not accept responsibility for any problems that may occur through incorrect

installation.

Arcade single lever bidet mixer

with pop up waste

DIMENSIONS

Ø45

Ø65

NOTE: ALL DIMENSIONS IN MILLIMETRES

ARC13, ARC13 CHR

Ø35

148