Siemens SITRANS LVL200E Manuale di istruzioni - Pagina 18

Sfoglia online o scarica il pdf Manuale di istruzioni per Interruttore Siemens SITRANS LVL200E. Siemens SITRANS LVL200E 40. Vibrating switches
Anche per Siemens SITRANS LVL200E: Manuale di istruzioni per l'uso (44 pagine), Manuale di istruzioni per l'uso (16 pagine), Manuale di istruzioni per l'uso (40 pagine)

5 Connecting to power supply

Electronics and connec-

tion compartment

Remove approx. 10 cm (4 in) of the cable mantle, strip approx.

1 cm (0.4 in) of insulation from the ends of the individual wires

Insert the cable into the sensor through the cable entry

Open the terminals with a screwdriver

Insert the wire ends into the open terminals according to the wiring

plan

Tighten the terminals with a screwdriver

Check the hold of the wires in the terminals by lightly pulling on

them

Tighten the compression nut of the cable entry. The seal ring must

completely encircle the cable

10 Screw the housing cover on

The electrical connection is ﬁnished.

5.3 Wiring plan, single chamber housing

The following illustrations apply to the non-Ex as well as to the EEx-d

version.

Fig. 10: Electronics and connection compartment, single chamber housing

Control lamp

DIL switch for mode adjustment

DIL switch for switching point adaptation

Ground terminal

Connection terminals

SITRANS LVL200E - CONTACTLESS ELECTRONIC SWITCH

2 0 - 2 5 3 V A C / D C

1 2

m a x 4 0 0 m A

0,5 g / cm 3

0,7 g / cm 3

1 2