Siemens SITRANS LVL200E Manual de instrucciones - Página 18
Navegue en línea o descargue pdf Manual de instrucciones para Interruptor Siemens SITRANS LVL200E. Siemens SITRANS LVL200E 40 páginas. Vibrating switches
También para Siemens SITRANS LVL200E: Manual de instrucciones (44 páginas), Manual de instrucciones (16 páginas), Manual de instrucciones (40 páginas)
Imprimir página
5 Connecting to power supply
Electronics and connec-
tion compartment
18
3
Remove approx. 10 cm (4 in) of the cable mantle, strip approx.
1 cm (0.4 in) of insulation from the ends of the individual wires
4
Insert the cable into the sensor through the cable entry
5
Open the terminals with a screwdriver
6
Insert the wire ends into the open terminals according to the wiring
plan
7
Tighten the terminals with a screwdriver
8
Check the hold of the wires in the terminals by lightly pulling on
them
9
Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
10 Screw the housing cover on
The electrical connection is finished.
5.3 Wiring plan, single chamber housing
The following illustrations apply to the non-Ex as well as to the EEx-d
version.
5
Fig. 10: Electronics and connection compartment, single chamber housing
1
Control lamp
2
DIL switch for mode adjustment
3
DIL switch for switching point adaptation
4
Ground terminal
5
Connection terminals
SITRANS LVL200E - CONTACTLESS ELECTRONIC SWITCH
C
2 0 - 2 5 3 V A C / D C
1 2
1 2
m a x 4 0 0 m A
+
L
+
N
L
N
0,5 g / cm 3
A
0,7 g / cm 3
B
1 2
1
2
3
4