CAB EOS5 Manuale dell'operatore - Pagina 14

Sfoglia online o scarica il pdf Manuale dell'operatore per Cutter CAB EOS5. CAB EOS5 15.
Anche per CAB EOS5: Manuale di servizio (20 pagine)

Cleaning and Replacing the Blades

Figure 5

4. If the blades are very dirty with residues of adhesive or if they are worn,

change blades:

 Turn the shaft (6) clockwise using a torx wrench TX10 until the gear

racks (7) cannot engage anymore.

 Pull the upper blade (9) out of the guides (8).

 Take out the lower blade (10).

 Remove deposits on the blades with label remover and a soft cloth.

 If necessary, replace the blades.

 Push the lower blade down into the guides (11).

 If necessary, put the springs (12) back into the spring retainers (13).

 To re-mount the upper blade push the lower blade down on the cover

and push the upper blade into the guide until the gear racks (7) can

engage with the gear wheels (5).

 Turn the shaft (6) counterclockwise using a torx wrench TX10 until the

blade reaches the upper limit.

5. Fit the blade unit (3) according to Fig. 4 into the axes (2) and fold it

towards the cover (4) until it snaps in.

6. Fold the cutter up to the printer.

Replacing the Blades

Figure 6

Springs