CAB EOS5 Operatör El Kitabı - Sayfa 14

Kesici CAB EOS5 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. CAB EOS5 15 sayfaları.
Ayrıca CAB EOS5 için: Servis Kılavuzu (20 sayfalar)

Sayfayı Yazdır

Cleaning and Replacing the Blades

Figure 5

4. If the blades are very dirty with residues of adhesive or if they are worn,

change blades:

 Turn the shaft (6) clockwise using a torx wrench TX10 until the gear

racks (7) cannot engage anymore.

 Pull the upper blade (9) out of the guides (8).

 Take out the lower blade (10).

 Remove deposits on the blades with label remover and a soft cloth.

 If necessary, replace the blades.

 Push the lower blade down into the guides (11).

 If necessary, put the springs (12) back into the spring retainers (13).

 To re-mount the upper blade push the lower blade down on the cover

and push the upper blade into the guide until the gear racks (7) can

engage with the gear wheels (5).

 Turn the shaft (6) counterclockwise using a torx wrench TX10 until the

blade reaches the upper limit.

5. Fit the blade unit (3) according to Fig. 4 into the axes (2) and fold it

towards the cover (4) until it snaps in.

6. Fold the cutter up to the printer.

Replacing the Blades

Figure 6

Springs