Cisco Profile Series Manuale di installazione - Pagina 28

Sfoglia online o scarica il pdf Manuale di installazione per Sistema di conferenze Cisco Profile Series. Cisco Profile Series 44. Jbod on the 12g sas modular raid controller
Anche per Cisco Profile Series: Manuale introduttivo (41 pagine), Manuale d'uso (44 pagine), Manuale d'uso (7 pagine), Manuale introduttivo (35 pagine), Manuale di riferimento rapido (2 pagine), Manuale di configurazione (13 pagine), Scheda di installazione (2 pagine), Manuale di installazione (2 pagine), Manuale di avvio rapido (4 pagine), Manuale di avvio rapido (4 pagine), Manuale di installazione (16 pagine), Manuale introduttivo (32 pagine), Manuale (16 pagine), Manuale introduttivo (42 pagine), Manuale introduttivo (46 pagine)

Figure 2-7

Mount the router into the rack using the screws provided in the rack.

Step 2

Installing the Router Ground Connection

The router must be connected to a reliable earth ground. Install the ground wire in accordance with local

electrical safety standards.

•

This equipment needs to be grounded. Use a green and yellow 12 to 14 AWG ground wire to connect

Warning

the host to earth ground during normal use. Statement 242

To install the ground connection, follow these steps:

Step 1

Strip one end of the ground wire to the length required for the terminal.

Crimp the ground wire to the ring terminal using the wire crimper.

Step 2

If you choose to install the power switch lock, perform

Step 3

Step 6

Step 4

Attach the ring terminal to the chassis. Use the single screw provided. Tighten the screws to a torque of

8 to 10 inch-pound (0.9 to 1.1 newton meter) as shown in

Install the power switch lock. Tighten the screws to a torque of 8 to 10 in-lb (0.9 to 1.1 N-m). Torque the

Step 5

hex standoff to the same torque.

Connect the other end of the ground wire to a known reliable earth ground point at your site.

Step 6

Cisco 800M Series Integrated Services Router Hardware Installation Guide

2-8

Attaching the Brackets (I/O side facing the user - Offset rack mount)

For NEC-compliant grounding, use size 14 AWG (2 mm2) or larger copper wire and a ring terminal

with an inner diameter of 1/4 in. (5 to 7 mm).

For EN/IEC 60950-compliant grounding, use size 18 AWG (1 mm2) or larger copper wire.

and

Step

Offset rack mount

Chapter 2

Step 5

Step

7. Otherwise, perform

Figure

2-8.

Installing the Router

Step